show mac address-table shows the MAC address, VLAN ID, and port for each device in the table. To delete the static entry, use the no form of this command. Then on layer 3 device to resolve it to ip address take the mac from above and run. If some MACs are missing, the problem exists between the device you're on and the device that is missing. Some of our favorite commands to use on the Adtran NetVanta 1238, 1550 etc switches and routers. To configure a static entry for the MAC address table, use the mac address-table static command. sh mac address-table interface gigabitEthernet x/x. Run the command and see what MACs show up-you should see MACs from the whole VLAN (from the wireless clients on the AP to the pfSense box).

The 'show mac-address-table' (or whatever the syntax is for your switches) is very helpful in isolating that. Your problem is likely due to VLAN tagging somewhere. If you wanted a native VLAN for some reason, you could make either VLAN native and as long as both ends matched, it should still work. x print ip arp print interface bridge host print ip route print ip route check 192.168.10.45ip route check 192.168.10.0 routing ospf neighbor print system. If some MACs are missing, the problem exists between the device youre on and the device that is missing. If there is a scriptable tool which could store all the mac address table of the pool in a same file, i'm taking it. Run the command and see what MACs show up-you should see MACs from the whole VLAN (from the wireless clients on the AP to the pfSense box). For each switch i am forced to export into excel the mac address table then, with a macro i can match users who are connected on it. If I were setting it up, I would want both ends of that trunk link to be 'switchport trunk allowed vlan 10,20' and no native VLAN. The 'show mac-address-table' (or whatever the syntax is for your switches) is very helpful in isolating that. Adding additional WAP's will have the effect of cluttering up your RF environment and increasing interference between devices (especially in the 2.4 Ghz range, where channel choices are quite limited).Д«ut, on the original question: I would focus on the trunk link between the MDF and IDF. Bombarded with jargon, no wonder networking beginners get lost. I would avoid that option if you want optimal WiFi performance. Is it possible to purchase additional access points and leave it separate? It really is nice security-wise to have an physically separate guest network.

Adtran show mac address table